Overview of unencrypted secure printing

Celiveo Pull Printing can secure the release of unencrypted jobs sent directly to a Celie-enabled printer or to a CSVP (Celiveo Shared Virtual Printer).
These jobs are controlled and tracked as “Celiveo non-encrypted jobs.”
Note that the jobs themselves are not encrypted; only their release is made secure by being only feasible by the addressee.

Modifying the device type

You need to modify the device type to interface SAP and Celiveo. Please refer to your SAP Output Management technical guides on how to modify a device type.

Replacing the job header sequence

You must replace the existing job header in the device type with the sequences listed below.
Please note that all lines shown should be appended one after the other without any carriage returns between them. (Carriage returns were inserted in the listing below only for the purpose of improved readability.)

Celiveo SAP secure print job header

Replacing the job trailer sequence

The following sequences must be used to replace the existing job trailer in the device type.

celiveo SAP Secure Print job trailer

Activation of the device type

Once the device type is saved, activate it in the production environment and use it to produce documents.
To verify that the modification is active, print to a file on disk, open it with any text editor and verify its header/footer meets the requirement.

Last modified: 14 June 2024


Was this helpful?

Yes No
You indicated this topic was not helpful to you ...
Could you please leave a comment telling us why? Thank you!
Thanks for your feedback.

Post your comment on this topic.

Post Comment